QUAKER STATE OIL REFINING CORPORATION -- QUAKER STATE 2-CYCLE OUTBOARD LUBRICANT  -- 9150-00B170002
<pre>=====================  Product Identification  =====================

Product ID:QUAKER STATE 2-CYCLE OUTBOARD LUBRICANT
MSDS Date:10/09/1985
FSC:9150
NIIN:00B170002
=== Responsible Party ===
Company Name:QUAKER STATE OIL REFINING CORPORATION
Address:BOX 989
City:OIL CITY
ZIP:16301
Country:US
Info Phone Num:814-676-7676
Emergency Phone Num:814-676-7676
CAGE:DO899
=== Contractor Identification ===
Company Name:QUAKER STATE OIL REFINING CORPORATION
Box:989
City:OIL CITY
State:PA
ZIP:16301
Country:US
Phone:814-676-7676
CAGE:DO899

=============  Composition/Information on Ingredients  =============

Ingred Name:STODDARD SOLVENT
CAS:8052-41-3
RTECS #:WJ8925000
Fraction by Wt: 17%
OSHA PEL:500 PPM
ACGIH TLV:100 PPM; 9293

Ingred Name:MINERAL OIL (EXPOSURE REGULATED AS 'OIL MIST')
CAS:8012-95-1
RTECS #:PY8030000
Fraction by Wt: >75%
OSHA PEL:5 MG/M3
ACGIH TLV:5 MG/M3/10 STEL;9192

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Health Hazards Acute and Chronic:ACUTE: SWALLOWING-IRRITATION TO MOUTH
    AND THROAT. MAY ALSO CAUSE NAUSEA AND DIARRHEA. HOWEVER, ASPIRATION
    OF HYDROCARBON LIQUIDS INTO THE LUNGS MAY CAUSE PNEUMONITIS. SKIN
    ABSORPTION-NO DATA AVAILABLE . INHALATION-IRRITATION TO RESPIRATORY
    PASSAGES AT LOW LEVELS. THE CREATION OF VAPORS AND MISTS IS
    UNLIKELY.
Effects of Overexposure:SKIN CONTACT-STODDARD SOLVENT IS A DEFATTING
    AGENT. PROLONGED AND REPEATED CONTACT MAY CAUSE DERMATITIS.  EYE
    CONTACT-MAY CAUSE EYE IRRITATION IF CONTACT OCCURS.

=======================  First Aid Measures  =======================

First Aid:SWALLOWING: IF MATERIAL IS SWALLOWED, DO NOT INDUCE VOMITING
    AND CONTACT A PHYSICIAN. SKIN-WASH SKIN THOROUGHLY WITH SOAP AND
    WATER. LAUNDER SOILED CLOTHING. INHALATION-ALTHOUGH INHALATION OF
    THIS MAT ERIAL IS UNLIKELY, IF RESPIRATORY DISCOMFORT OR IRRITATION
    OCCURS DUE TO INHALATION MOVE PERSON TO FRESH AIR. CONTACT A
    PHYSICIAN IF DISCOMFORT OR IRRITATION CONTINUES. EYES-FLUSH WITH
    WATER FOR 15MIN

=====================  Fire Fighting Measures  =====================

Flash Point Method:COC
Flash Point:135 F
Extinguishing Media:CO2, DRY CHEMICAL, FOAM, WATER FOG.  H20 MAY BE
    INEFFECTIVE IN FIGHTING AN OIL FIRE UNLESS USED BY EXPERIENCED FIRE
    FIGH
Fire Fighting Procedures:FOR LARGE STORAGE FIRES-DO NOT ENTER ANY
    ENCLOSED OR CONFINED SPACE WITHOUT FULL PROTECTIVE EQUIPMENT
    INCLUDING SELF-CONTAINED BREATHING APPARATUS.
Unusual Fire/Explosion Hazard:AS LIQUID EVAPORATES, VAPORS ARE FORMED
    WHICH CAN IGNITE. THESE VAPORS SPREAD TO LOW AREAS AND MAY BE
    IGNITED BY VARYING SOURCES.

==================  Accidental Release Measures  ==================

Spill Release Procedures:CLEAN UP SPILLS AS SOON AS POSSIBLE. ABSORB
    LARGE SPILLS WITH COMMERCIALLY AVAILABLE ABSORBENT MATERIALS, SUCH
    AS ABSORBENT CLAY.

======================	Handling and Storage  ======================

Handling and Storage Precautions:COMBUSTIBLE LIQUID (135 F-FLASH
    POINT): DO NOT STORE NEAR HEAT OR OPEN FLAMES.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NOT APPLICABLE FOR INTENDED USE. HOWEVER, IF
    UNUSUAL OPERATING CONDITIONS CREATE CONCENTRATIONS IN EXCESS OF THE
    TLV, AN APPROVED RESPIRATOR IS RECOMMENDED.
Ventilation:NONE NEEDED FOR INTENDED USE. SPECIAL VENTILATION IS
    NECESSARY ONLY IF UNUSUAL OPERATING CONDITIONS CREATE CONCENTRATION
Protective Gloves:IMPERVIOUS PROTECTIVE GLOVES
Eye Protection:SAFETY GLASSES OR A FACE SHIELD
Other Protective Equipment:NONE NORMALLY NECESSARY FOR INTENDED USE.
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:>310 F
Vapor Pres:N/D
Vapor Density:>1
Spec Gravity:.87
Evaporation Rate &amp; Reference:<1
Solubility in Water:NIL
Appearance and Odor:GREEN LIQUID. HYDROCARBON ODOR.
Percent Volatiles by Volume:17

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HIGH TEMPERATURES AND OPEN FLAME.
Hazardous Decomposition Products:CARBON DIOXIDE, WATER VAPOR. MAY
    PRODUCE OXIDES OF SULPHUR, NITROGEN AND PHOSPHORUS.
Conditions to Avoid Polymerization:HIGH TEMPERATURES AND OPEN FLAME.

====================  Disposal Considerations  ====================

Waste Disposal Methods:PLACE CONTAMINATED MATERIAL IN DISPOSABLE
    CONTAINERS AND BURY IN AN APPROVED LANDFILL SITE PER LOCAL, STATE
    AND FEDERAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.